You can also check if the RFC is obsolete and it should be good to delete. This monitoring function displays various elements in the inbound queue: The sender. I have refer the discussion of inbound and outbound queue but still I havet clear that What is Inbound and. You will have more information than the first Transaction. I am a BI Trainee and I am refer the SMQ1, SMQ2. In other words, if a qRFC with inbound queue exists, it means that an outbound queue also exists in the sender system. Compress Data: In general, the data is always written to the inbound table. This object is not suitable for reporting and analysis. The extraction process always reads the data in the inbound table againfor delta extraction or full extraction. Check Registration of Destinations with SMQSīy Destination, check the TRFC Monitor and QRFC Monitor at SMQS Tcode. Inbound Queue Only: No data is saved in the change log. Often, you can delete your own blocked message in the SAP RFC queue. Select the registration and enter the required values for the queue. The log should show that it will flag 1 message for archiving (“No QRFC entry found.It is possible to run Delete a blocked entries ( some authorizations must be assigned ). On the initial screen, you see a list of all registered queue names. Now execute the report RSXMB_CHECK_MSG_QUEUE:Įnsure that you enter the specific message ID, then enter the PIPELINE ID (same as that shown in column PIPELINE in SXMB_MONI), select all status to search for and then select TEST RUN: Once you’ve done this, you can then use report RSXMB_CHECK_MSG_QUEUE to restore the messaging system integrity by resetting the original message status to cancel it. Instead, in this exceptional case, you can delete the message in SMQ2. Incase of errorous data, the respective object (say WorkOrder object in SAP Work Manager application) is locked and respective transactions on that object are hold in the queue. SAP notes state that you should NEVER delete messages directly from SMQ1 or SMQ2 as this leaves the messaging system in an inconsistent state. Inbound queue can be configured to record all the incoming Mobile transactions irrespective of being valid or contain errorous data. You may also be blowing the ICM http buffer, visible in the SMICM log file:īut, you can’t cancel the message in SXMB_MONI, as it is still scheduled on the QUEUE (“still scheduled in queue XBTS*”): The message is visible in transaction SMQ2 (inbound queue) for a few hours/days/months:Īnd it’s consuming significant resources, visible in SM50: The QIN Scheduler is activated (if it is not already) as soon as a qRFC. Symptom It is necessary to stop the inbound queue (qRFC) in transaction SMQ2 to analyse it. (This solution is based on SAP note 688147). Since inbound queues are client-dependent, there is a QIN Scheduler for each client. The same can be replicated in two different SAP systems Step2. The below post demonstrates the inbound queue in the one SAP system. Then why is that in sxmbmoni, we alwys see outbound queues (XBTOE10002) and not the inbound queues Sender side Adapter engine->Inbound queue (SMQ2)->Integration engine->Outbound queue (SMQ1)->Receiver side adapter engine. The inbound queue is always associated with an out bound queue for better tracking of the complex process. 3. Sender queues are outbound and receiver are inbound queue. These include: 1.Network problems 2.Non-existent RFC destination, etc. Scenario: You have a large message that is stuck in the INBOUND (XBTS*) queue of an integration server (maybe an ABAP proxy). The system differentiates between two types of error when processing qRFC modules: A.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |